Brands
|
N/A
Apollo
|
Description
|
N/A
CAP 1
|
Manufacturer
|
N/A
CLEMCO
|
Weight
|
N/A
73 lb
|
Related Clemco Literature
|
N/A
Abrasive Blast Safety Practices (22090) Apollo Safety System Product Study (07764) Blast off 2 (09294) Contractor Series Catalog (21385)
|
Options & Accessories
|
N/A
Apollo 20 LP with hose (21423) (QUOTE)Apollo 60 LP with hose (22082) (QUOTE)Elevated Air Inlet Kit (21839) (QUOTE)Remote Air Extension (21838) (QUOTE)Remote Air Inlet (50 ft) (21837) (QUOTE)
|
Requirement for Operation
|
N/A
The following items are required for operation, but are not included with this equipment:- Electric power supply - 110-115 volt, 60 cycle, 14 amp
- NIOSH approved low-pressure, type CE-supplied-air respirator approved to operate at 10 psi or less, suitable for the application
- Appropriate approved respirator hose
- Output from the ambient air pump must meet the standard for Grade D breathing air, as defined by the Compressed Gas Association, Commodity Specification: G-7.1
|
Description of Operation
|
N/A
- The Apollo Ambient Air Pump must be placed outside of the blast environment in an area free of airborne contaminants. These potential contaminants include, but are not limited to, the following - fumes from paints and solvents, exhausts from vehicles and compressors, smoke from burn barrels, and dust from abrasive blasting or other construction activities.
- The ambient air pump moves air from a clean location to the inside of the low- pressure respirator. To increase its effective range, the ambient air pump can be connected to an optional remote inlet kit - which allows the air inlet to be located up to 100 feet from the pump or up to 200 feet from the operator.
- An optional elevated air inlet raises the inlet three feet above the pump.
Before blasting begins, and before putting on the respirator, the operator connects the respirator hose to the ambient pump and to the fixed-orifice air inlet at the respirator. The operator turns on the pump, adjusts the pressure, and checks for leaks, then puts on the respirator in a clean environment. - After blasting, the operator keeps the respirator on and connected until he or she reaches an area free of airborne dust and contamination.
- The air connection uses a special quick- connect fitting that allows air to flow, even when not connected to the respirator. This keeps hazardous dust or other contaminants from entering the hose at the connection point.
|
Approval and Certifications
|
N/A
UL listed, CSA approved
|
Model
|
N/A
Cap-1
|
Height
|
N/A
22.5 in
|
Width
|
N/A
8 in
|
Depth
|
N/A
12 in
|